Order by phone... 1-866-278-6653 / 1-908-273-5401

Hand Casting | Page 2

 

Hand Casting Step 5

Figure 6

 

Once you have created a smooth alginate mix, the hand is inserted into the conatiner holding the PC mouse. A helper steadies the hand so that it stays in the middle while the MoldGel sets. This process takes 4-5 minutes.

Hand Casting Step 6

Figure 7

   

The helper raps on the outside of the container for several minutes helping trapped air escape to the surface.

Hand Casting Step 7

Figure 3

   

After the MoldGel has set to a rubber-like consistency,  the model wriggles their fingers to break the suction of the MoldGel against the skin. Releasing the mouse, and with a slow upward pressure the hand is removed.


Hand Casting Step 8

Figure 8

   

The next step is to mix the CastRite casting plaster according to label directions. A whisk is used for this procedure as well. Though gloved hands work just as well. The mixture is ready when it reaches the consistency of yogurt.

Hand Casting Step 9

Figure 9

   

This picture shows the CastRite sitting on top of the water. When this phenomenon occurs, you have added enough plaster to the water. 


Click next arrow to continue.

   


Last Page   NEXT    Next Page