ArtMolds Affordable Vacuum Chamber
This low price high quailty vacuum chamber is all you need to quickly de-air your rubber. Unlike those thin, flimsy aluminum "Lobster Pots," our affordable vacuum chambers won't dent or ding. Contact us now for information or to place your order!
The ArtMolds' Affordable Vacuum Chamber
Take the next step in studio equipment by adding that important affordable vacuum chamber. To assure bubble-free mold rubber when mixing polyurethane, epoxies and silicones, a vacuum chamber is required. The low cost ArtMolds' affordable vacuum chamber is the perfect addition to the small studio, school, university or protype lab. The ArtMolds' Affordable Vacuum Chamber has been engineered for deairing (eliminating air bubbles) mold making and casting rubbers. Though the price point of our vacuum chamber may be low, its design does not skip on prefessional grade quality -- and safety - and it resists, dents and dings associated with those metal pots.
This PVC vacuum chamber, along with ½-inch opitically clear acrylic plates make a safe and efficient unit. This affordable vacuum chamber includes all machined brass fittings, including a pet cock exhaust valve, a plastic hose and hose barb to connect your vacuum pump, a vacuum gauge, a pair of matched rubber gaskets, and a set of ½-inch clear acrylic plates. All you need is a vacuum pump for your new affordable vacuum chamber that will pull 29-inches of mercury (Hg) at sea level, needed to deair your materials.
Affordable Vacuum Chamber Specifications:
Capacity: 4-gallon affordable vacuum chamber (approximately)
Dimensions: 10-inch diameter by 10-inch tall
Maximum Pull: 29-inches of mercury (Hg) at sea level
24-Hg at elevation of Denver, CO
Weight: 20-pounds / Shipping weight 22-pounds
Package Size: 12" x 12' x 12"
Mix your rubber according to the manufacturers directions. Use a container that holds at least four times the amount of material you are vacuuming to allow for the expansion of the material. Once your vacuum chamber reaches 29-inches of mercury (at sea level), the material will begin to rise (resembling foam) for a minute or two. When the material falls it will plateau and not rise any more. You will want to continue opertaing the vacuum chamber for another 2-3-minutes to make certain all of the air has been removed from your material. Open the petcock of your vacuum chamber to allow air inside, remove your material from the vacuum chamber. Pour the material slowly starting from the corner of the mold box, or mold, letting the material to flow freely into the box or mold cavity. This method will usually not introduce any new bubbles into the vacuumed material. To insure that the material is totally devoid of air bubbles you can place the entire mold/mold box into the chamber for an additional few minutes. This will assist the material into difficult areas of the mold/mold box. Order now click this link for the affordable vacuum chamber.